On this page, we have shared the download link and guide to install the Motorola XT2013-1 (Motorola One Action) firmware flash file using the fastboot method. Here you will find all stock firmware zip files for all the supported regions with Motorola One Action XT2013-1.

If you are someone who wants to restore the device back to factory firmware, then this guide is for you. By using this guide, you can fix certain software-related issues such as hard brick, soft brick, WiFi, or Bluetooth issue, fix lag or stutter or even you can downgrade the device anytime.

Also Read

List of Best Custom ROM for Motorola One Action [How to]

Download and Install AOSP Android 13 on Motorola One Action

Steps to Install Motorola XT2013-1 Stock Firmware (Flash File)

Now, if you’re ready to flash the stock firmware manually on your Motorola One Action XT2013-1 device then you need to download the flash tool, firmware file, and necessary drivers. So, without wasting any more time, let’s get into it.

Pre-Requirements:

  • This ROM is supported for the Motorola One Action XT2013-1 (Troika) variant only.
  • Make sure that your device should be charged at least 50% or higher.
  • You will require a PC or Laptop with a USB Data Cable.
  • We always recommend our readers take a full data backup of the device for safety purposes.
  • Install Motorola USB Drivers and Rescue and Smart Assistant Tool on your PC
  • To flash, you must download the ADB and Fastboot tool

Motorola One Action XT2013-1 Firmware Flash Files:

Firmware Installation Guide:

Check out the firmware flashing guide below for the Motorola One Action XT2013-1. First, make sure to install or extract the adb and fastboot tool on your PC. Now enter the bootloader on your device.

Disclaimer:

Step 1. Bootloader Mode

Enter bootloader mode on your phone. To boot first, turn your phone off. Once your device turned off completely, press and hold volume down, and turn it on. You should see the bootloader screen.

Step 2. Connect Your Device to PC:

After booting your Motorola One Action into bootloader mode, now connect it to the PC using the USB Cable.

Step 3. Download Stock ROM/Firmware:

To get the full ROM, you can use the LMSA or Rescue and Smart Assistant Tool. Download the zip file and copy it to somewhere on your PC. LMSA tool will unzip the file and will remove the zip file you downloaded.

You can also download the full stock ROM from the above download flash file section on this guide.

Step 4. Flashing Guide:

  • The next step is to open the command window and go to the adb folder
  • Download the flash file and extract it inside the ADB platform-tools folder.
  • After extracting, look for the file name flash.bat and double click.
  • In the command window, you have to enter the F key and press ENTER key to flash the full firmware.
  • After finishing the flash process, you can reboot to system.

That’s it, guys. We hope this guide was helpful to you. Feel free to ask in the comment below for additional queries.